Tel: 64-9-478 7378  /  Fax 64-9-478 7328     Email : highperformancemodels@xtra.co.nz

SPECIALISTS IN R/C PERFORMANCE MODEL BOATS FOR MEN ..........................NO TOYS FOR BOYS
 
 
 
 
 
 
 
 
 
 
 
 
         
   

BH HANSON PRODUCTS

  
         
         
         
         
         
         
    PRO - CLUTCH MOUNT  
   

Designed specifically for the BH Hanson Pro Clutch, this new drive side mount works with a quick change recoil side mount. Both are vertically slotted for quick engine removal and getting exact shaft alignment. The compact design allows you to get rearward engine placement without radio box clearance problems. Sold as a set with all mounting hardware.

  
         
    QUICK RELEASE MOUNT  
    Heavy duty black anodized with all mounting hardware  
         
 

  CLASSIC MOUNT  
    Quick and Easy mounting system for 5 inch rails  
         
    CLUTCH  
   

The B.H. Hanson Pro Clutch is designed for long life and trouble free use with it's hard anodized clutch bell and sealed bearings. It uses a genuine Zenoah rear housing and clutch shoes along with BH Hanson's billet enclosed and ventilated front end for low dust operation. It comes with a drive collete and all hardware needed to mount on your Zenoah engine. 

  
         
    WATER PUMP  
   

Water Pump, operated by crankcase pressure. A must for clutch engines. Comes with mounting bracket, tygon line and fitting.

  
         
    THROTTLE CABLE  
         
         
    COIL RELOCATION BRACKET  
    Use this bracket when you need to move your spark coil from under the carb. Comes in black anodized or natural finish. Complete with mounting hardware as shown.  
         
         
    METAL RECOIL RING  
    Metal Ring Replaces the standard one in the recoil  Starter  
         
      GASKET  
    These gaskets help solve the heat transfer problem that allows the inserts to pull out of the factory Zenoah Iso block and cause air leaks.. The iso block gasket is supplied as standard equipment on BH Hanson Pro Iso block gasket supplied with washers.  
         

 

 Tel: 64-9-478 7378  / Fax 64-9-478 7328 Email : highperformancemodels@xtra.co.nz

THIS WEBSITE IS DESIGNED & MAINTAINED BY KIM KOCKOTT